Author Archives: Adam

Gap Filler Pads

Posted by Adam in Thermal Interface Materials
Can fill up larger gaps between heat sinks and components; Very easy to use (supplied in pre-cut shapes). Require higher Read More

Phase Change Materials

Posted by Adam in Thermal Interface Materials
Very good thermal performance; Viscosity prevents leaking or “pump out”;  Easy to use (manufacturing friendly). Lower thermal conductivity than grease; Read More

Thermal Greases

Posted by Adam in Thermal Interface Materials
Best thermal performance; Require very small pressure for good contact; Widely used in electronics. Difficult to apply and remove; May Read More

CNC Machining

Posted by Adam in Manufacturing Methods
CNC machining is the most versatile process that can produce a wide range of products with almost any metal or Read More

Die Casting

Posted by Adam in Manufacturing Methods
Precision die casting is a versatile process that can produce parts with intricate geometry. Because in most of the cases, Read More

Cold Forging

Posted by Adam in Manufacturing Methods
Cold forging is a high pressure and low temperature process. It produces part with outstanding quality and surface finish. Pure Read More

Extrusion

Posted by Adam in Manufacturing Methods
If a part can be extruded, it is always a good idea to have it made that way. Both the Read More

How Orientation Affects Heat Sink Performance?

Posted by Adam in Q&A
The orientation of pin fin heat sink has been found to exert only a minor influence on the heat transfer. Read More
© 2024 MyHeatSinks, Inc. All Rights Reserved.